Sew Busy
  • Home
  • Apparel
  • New Designs
  • CUSTOM Designs
  • CONTACT
  • Blog
  • Jet Aerobatics BLOG
Picture
POWERBOX CHAMPION SRS
$548.00


To order or for more information press button below
Order Champion SRS
Features 
  • PowerBus: 2 outputs, 16 + 2 channels, compatible with other servo bus systems
  • Servo-Match function: servo centre, end-points and reverse for all 24 servo outputs
  • Door sequencer: six freely programmable outputs with set-up assistant
  • SRS: Serial Receiver System provides the facility to use receivers with serial interface: Spektrum DSM2 and DSMX, Multiplex M-Link, Futaba S-Bus, HoTT, JR X-BUS and Jeti R-SAT2
  • Unrestricted channel assignment for all 24 PowerBox outputs
  • Graphic LCD screen with 128 x 64 pixels
  • Extremely user-friendly menu-based programming using the SensorSwitch
  • Up to 18 channels - depending on the radio control system in use
  • Signal amplification and interference suppression for all 24 outputs
  • Flight recorder, recording of lost frames, fail-safe events and all battery data
  • Variable frame rate, range 9ms – 21ms
  • Two 16-bit processors for fast, high-resolution signal processing
  • 2 x double-regulated output voltages for receivers and servos
  • 2 regulated voltage ranges with independent selection facility, 5.9V or 7.4V
  • Connection facilities for Spektrum, HoTT and Multiplex MSB downlink bus systems
  • Direct transmission of battery voltage and capacity to the transmitter
  • Separate voltage and capacity display for each battery
  • Minimum value memory alerts the user to voltage collapses
  • Large-area heat-sinks for high regulator performance
  • Regulator monitoring, regulator error indicator
  • Support for three battery types: LiPo, NiMH / NiCd, LiFePo
  • Suppression of any servo feedback currents which may occur
  • Updateable with PowerBox Systems USB Interface connectors
Technical Data

Operating voltage:    4.0V - 9.0V
Power supply:    2S LiPo, 2S LiFePo, 5S NiCd/NiMH
Current drain Power-on state:   185mA (with LCD)
Current drain Standby:   30µA
Maximum load current:   Peak 4x20A
Drop-out voltage:   0.3V
Output voltage:   5.9V and/or 7.4V regulated
Signal input:   serial
Supported RC systems Spektrum, Futaba, HoTT, M-Link, Jeti, JR
Receiver redundancy SRS
Channels 18
Servo sockets 24
Programmable servo outputs 24
Servo signal resolution 0.5µs
Signal frame rate
9ms, 12ms, 15ms, 18ms, 21ms
Screen
LCD, backlite
Integral door sequencer yes
Supported telemetry systems
Spektrum, HoTT, M-Link
Dimensions
136 x 82 x 20 mm
Weight
158g
Weight Sensor Switch
15g
Weight of LCD screen
65g
Temperature range
-30°C to +75°C

Picture
PRIVACY POLICY

Contact:

If you have any questions you can fill out this form or call Wayne at 404-395-7461.
Copyright sewbusy.com © 2025 | All rights reserved